|
Program Switch
... used to set up to different programs for automatic operation, or to
select a pre-set program (A, B or C) for semi-auto operation. After use
in either mode, switch position does not affect daily automatic operation.
Function Switch
... Set to the left, it stops a programmed watering cycle and any valves
that are on. In this mode, all programs are retained and the clock
continues. Watering will not resume until the switch is returned to
"RUN." Set to the left when it rains.
... Set in the middle, the switch enables the user to set new programs,
or change existing ones.
... Set to the right for normal, daily automatic operation.
Semi-Auto Start Button
... Used with Program Switch. When depressed, immediately starts program
selected (A, B or C) regardless of automatic program cycle.
Manual Start Button
... Used with Multi-Function Dial and +/- Buttons. When depressed, operates
any selected single valve for an amount of time selected by user.
Multi-Function Dial
... Use with Manual Start Button for single valve operation.
... Use to set, check or change program information in conjuction with
Number Advance Buttons. After using, always return dial to "Current Time."
+/- Buttons
... Use with Multi-Function Dial or in Manual Mode to set or change program
information. Single finger taps to either button advance or reduce data one
character at a time. Holding either button down advances at a rate of 12 characters/sec.
LCD Display
... Shows current operation
|
