Installing the Outdoor Model Controller
Use the mounting template to locate the 3 mounting holes. Although you can locate your outdoor model almost anywhere, it is best to avoid direct exposure to spinkler spray. Since this device is "hard wired," keep in mind that you must run electrical cable to it. NOTE: Be sure that the ground wire is connected and that the controller is not sharing the same circuit as a large applicance. Open the door to your controller, then pop the control module up by flexing the inside tabe to your right. Locate your controller over the area you marked with the template, then drive 3 screws through the holes provided. Use wall anchors, toggle bolts or other appropriate fasteners when attaching to other that wall studs. Insert a battery, see section 3.0. CAUTION: Do not connect to electricity until after valves are connected, see sections 6.0 and 7.0.